TY  - THES
T1  - Influence of biogas-digestate processing on composition, N partitioning, and N2O emissions after soil application
A1  - Petrova,Ioana
Y1  - 2024/03/13
N2  - The ever-growing need for agricultural products represents a global issue, particularly with a view to the limited availability of cultivable land. According to the latest estimates, the arable land per capita decreases and, in 2050, is expected to account for about 60% less than in the 1960s.
In order to meet the demand, agriculture has evolved into industrial-like structures. This development often goes along with nutrient surpluses (e.g., excess of nitrogen and phosphorus) and increased emissions, caused by mismanagement and inappropriate agricultural practices (e.g., over-fertilization). Biogas plants offer a possibility to valorize organic residues and wastes, but potentially aggravate this problem since additional organic residues (referred to as digestates) with considerable nutrient contents are generated as by-products.
A simple approach to adjust nutrient levels in the affected regions is the transfer of manures and digestates. However, to make this feasible, a reduction of water content (and consequently of total mass/volume) of digestates is required. Up to now, various techniques for digestate downstream processing are available. Previous research mainly addressed single processing stages or differences between feedstock mixtures. Only limited information was found about the influence of a completed downstream processing on total mass reduction and nitrogen concentration in digestate. Studies about the (gaseous) N losses that occur after the application of the respective intermediate and final products to soils were equally scarce.
Therefore, the aims of the current doctoral thesis were to determine (i) the mass reduction achieved by the gradual removal of water within competing processing chains, (ii) the nitrogen partitioning after every single processing step and its recovery in the end products, and (iii) the amount of greenhouse gases (especially N2O) released after the application of intermediate and end products to soils in comparison to untreated, raw digestate.
For that purpose, two commercial, full-scale biogas plants were examined, which completely processed either the solid or the liquid fraction after mechanical screwpress separation of raw digestate. The separated solid fraction was subsequently dried and pelletized, while the liquid fraction was treated by vacuum evaporation with partial NH3 scrubbing. As final products, digestate pellets and N-enriched ammonium sulfate solution were generated. Calculation of a mass flow balance served as the basis for determining (total) mass reduction, the partitioning of fresh mass and nitrogen during digestate processing, and the recovery of initial N in the products. Additionally, the environmental impact of utilizing digestate as an organic fertilizer was studied by measuring the N2O release after application to soil under field and laboratory conditions. A further in-depth analysis was performed to observe the main factors influencing the production and release of climate-relevant N2O from digestate pellets.
It was found that the mass reduction caused by water removal during subsequent processing accounted for 6% (solid chain) and 31% (liquid chain) of the total mass of raw digestate. Liquid processing required 40% less thermal energy per ton of water evaporated than solid processing. At the end of the downstream processing, the recovery of initial nitrogen in pellets was 33% lower than in ammonium sulfate solution. Regarding the environmental impact of digestate application to soil, mechanical solidliquid separation showed the potential to reduce N2O emissions. Contrary to expectations, pelletizing of dry solid boosted the emissions, which was linked to the properties and composition of the pellet. Here, indigenous microbial activity triggered N2O production and release from denitrification immediately after wetting.
Overall, the present work has shown that the subsequent processing of separated solid or liquid digestate generates different products with individual benefits and challenges. Solid digestates are characterized by a high share of recalcitrant organic compounds and therefore can serve, e.g., as soil improver. After processing to pellets, they can be easily transported, stored, and commercialized. However, it is questionable whether the pelletizing process is advisable, since pellets emitted a considerable amount of GHGs during utilization. Liquid processing produces ammonium sulfate solution, which can be utilized as a valuable inorganic fertilizer rich in plant-available N.
Besides the discussed advantages, a final decision for or against digestate processing always depends on individual factors, such as local situation and financial means. Smart decision-making must include fertilizer properties, technological performance, and economic feasibility.
With a view to future research, additional aspects were identified, such as returning to a laboratory-scale biogas plant for more accurate digestate sampling and analysis, consideration of digestate storage and transport, and economic evaluation of the entire digestate value chain including the assessment of digestate fertilizer value (expressed as e.g., N use efficiency or N fertilizer replacement value).
KW  - Düngemittel
KW  - Biogasanlage
KW  - Stickstoff
KW  - Distickstoffmonoxid
KW  - Vakuumverdampfung
CY  - Hohenheim
PB  - Kommunikations-, Informations- und Medienzentrum der Universität Hohenheim
AD  - Garbenstr. 15, 70593 Stuttgart
UR  - http://opus.uni-hohenheim.de/volltexte/2024/2274
ER  -